Newsletter
Jeti USA
Jeti back
jeti logo
Transmitters
Receivers
Telemetry
Accessories
Axi Motors
axi back
axi logo
V2 Brushless
Sailplane
Cyclone
Accessories
Axi Motors
secraft back
secraft logo
Tx/Rx Accessories
Securing Systems
Fuel Systems
Hardware
TopmodelCZ
topmodel back
topmodel back
TD/E-Sailplanes
Scale Sailplanes
E-Hotliners
Pylon Racers
Opale
opale back
opale logo
Paragliders
Paramotors
Wings & Pilots

Elite Firmware Updates


MAV Manager


Download MAV Sense Device Manager Version 1.2.0b (September, 2021)
Release Notes: SE4 Version (April, 2021)
Release Notes: AMS Version 1.05 (September, 2021)
Release Notes: GPS Version 1.01 (September, 2021)


Voltario T60 Version 1.04

Added a new parameter for configuration: Voltage Hysteresis
The hysteresis is taken into account in case of switching supply from one battery to the other and back. It is important to keep the hysteresis low to enable equal discharging of batteries. On the other hand, it must be high enough to prevent fast battery switching under load.

There are three possibilities:
  • High hysteresis (LiPo) – approx. 1.2V. This is a default and recommended option for LiPo (Li-Ion)/LiPo (Li-Ion) or ESC-LiPo (Li-Ion) combination. This option can be used together with batteries of high internal resistance.
  • Medium – approx. 0.5V. This option can be used for equal discharging of low-resistance LiPo (Li-Ion) batteries.
  • Low (LiFe) – approx. 0.3V. Use this option together with low-resistance LiFe batteries.


FIRMWARE UPDATE

Firmware updates for the SE6 are transferred from a PC via the USB interface. The required programs and files are available at www.espritmodel.com Install the MAV Manager software and the USB drivers on your computer.

Check the system requirements.
  1. Disconnect all servos from SE6.
  2. Connect the USB interface to your PC, run MAV Manager and select the correct COM Port.
  3. Connect the SE6 according to the picture below.
  4. Select the file and press the Update button.
MAV Manager